Objectives

By the end of this course the candidate will be able to:

1. Work safely at all times, complying with health and safety legislation, regulations and other relevant guidelines.
2. Plan the fitting activities before you start them.
3. Obtain and prepare the appropriate tools and equipment for the hand fitting operations and check they are in a safe and usable condition.
4. Mark out the components/ materials for the required operations using appropriate tools, methods and techniques.
5. Cut and shape the materials to the required specification using appropriate tools and techniques.
6. Measure and check all dimensional and geometric aspects of the component are to the specification.
7. Re-instate the work area, clean tools and place them in there proper place after the fitting activity.

Requirements

There are no special requirements however candidates should have good dexterity and a knowledge of engineering drawings would be an advantage.

PLEASE NOTE THAT A PO NUMBER MUST BE PROVIDED AT TIME OF BOOKING OR YOUR BOOKING WILL NOT BE ACCEPTED

PLEASE ALSO NOTE THAT IN THE EVENT OF ANY DELEGATES NOT TURNING UP ON THE DAY, UNLESS WE HAVE BEEN ADVISED PRIOR TO THIS, YOU MAY BE CHARGED 30% OF THE COURSE FEES FOR COSTS INCURRED

Notes