Confirmed Dates:
• TBC
Duration:
4 Days (Mon-Thurs)
Timetable:
8.00 - 16.00
Course Cost:
£650 Per Delegate
Objectives
1. Electrical safety2. Electrical symbols and drawings
3. Introduction to AC motors (Induction)
4. Electricity at Work Regulations
5. Introduction to motor control circuits
6. Electrical techniques – use of cables, hand tools, terminations
7. Safe isolation – 'Permit to Work' system
8. Introduction to fault finding techniques
9. OHM's Law
10. Basic circuit properties, i.e. series and parallel, resistor circuits
11. Overview of 18th Edition Wiring Regulations [BS7671:2018]
12. Identification of electrical and electronic components
13. Use of electrical test equipment
14. Testing motor windings to identify any faults
15. Testing For Dead - Lock off and Tag Off
Requirements
This course can be followed by the Maintenance Fault Finding course in order to enhance your knowledge in maintenance.PLEASE NOTE THAT A PO NUMBER MUST BE PROVIDED AT TIME OF BOOKING OR YOUR BOOKING WILL NOT BE ACCEPTED
PLEASE NOTE THAT THIS COURSE WILL BE CANCELLED AND RESCHEDULED IF NO UPTAKE IS RECEIVED UP TO 14 DAYS PRIOR TO THE COURSE START DATE.
ALSO NOTE THAT IN THE EVENT OF ANY DELEGATES NOT TURNING UP ON THE DAY, UNLESS WE HAVE BEEN ADVISED PRIOR TO THIS, YOU MAY BE CHARGED 30% OF THE COURSE FEES FOR COSTS INCURRED.
Notes
WHO SHOULD PARTICIPATE;Mechanical Maintenance – Fitters / Technicians / Engineers / Supervisors who are required or wish to develop their electrical maintenance competencies.